Configuration With The Handheld Terminal; Configuration Via Dtm; Configuration Via Edd; Write Protection - ABB TTR200 Operating Instructions Manual

Communication and configuration
Pos: 19.5 /Konfiguration, Parametrierung/Temperatur/TTR200/Konfiguration mit dem Handheld-Terminal @ 15\mod_1195573997593_3101.doc @ 141958
7.1.2

Configuration with the handheld terminal

The configuration with the handheld terminal normally takes place at the factory before the
installation of the transmitter in an industrial plant.
The installation is to be realized according to the figure in the "Configuration types" paragraph.
Important
The connection of the cable for the handheld terminal is performed without polarity.
The configuration of the transmitter via the HART protocol can also take place during the
normal operation.
Pos: 19.6 /Überschriften/1.1.1/1-spaltig/Konfiguration mit dem DTM @ 18\mod_1204121317200_3101.doc @ 165553
7.1.3

Configuration via DTM

Pos: 19.7 /Konfiguration, Parametrierung/Temperatur/TTR200/Konfiguration mit dem DTM @ 18\mod_1204121432255_3101.doc @ 165599
Configuration can be performed with any FDT network applications that are approved for use
with the DTM (e.g., Smart Vision). The bus can be connected via FSK modem as well as HART
+ USB, Profibus + remote I/O or HART Multiplexer.
Pos: 19.8 /Überschriften/1.1.1/1-spaltig/Konfiguration mit der EDD @ 18\mod_1204121346262_3101.doc @ 165576
7.1.4

Configuration via EDD

Pos: 19.9 /Konfiguration, Parametrierung/Temperatur/TTR200/Konfiguration mit dem EDD @ 18\mod_1204121477731_3101.doc @ 165622
Configuration can also be performed with EDD master applications such as Siemens Simatic,
which is approved for use with EDD. In contrast to DTM configuration, EDD has process-
dependent, minor limitations such as configuration of a freestyle characteristic.
Pos: 19.10 /Überschriften/1.1/1-spaltig/S - U/Schreibschutz @ 1\mod_1147762681890_3101.doc @ 12424
7.2

Write protection

Pos: 19.11 /Konfiguration, Parametrierung/Temperatur/TTR200/Schreibschutz @ 15\mod_1195574376984_3101.doc @ 141982
To protect the device setup, the TTR200 provides write protection for software and hardware.
You can enable or disable the hardware write protection via the 2-pin DIP switch on the front of
the unit (see Fig. 3 page 14). To activate hardware write protection, move the first switch of the
2-pin DIP switch to the "on" position.
(The second switch of the 2-pin DIP switch has no function.)
Pos: 19.12 /======= Seitenumbruch ======== @ 0\mod_1126532365768_3101.doc @ 3830
24 TTR200 OI/TTR200-EN