Restoring The Factory Network Settings - FLIR F-Series Installation Manual

F-Series Installation Manual
3.5

Restoring the Factory Network Settings

The camera comes configured from the factory with a default IP address (192.168.250.116).
In some cases, it may be necessary to restore the network settings of the camera to the
original factory settings. If necessary, the camera IP address can be restored to this factory
default address by connecting a loopback device to the Ethernet port.
At each power-up, the system transmits a packet and then checks to determine if that same
packet has been received. Detection of the received packet indicates the camera has a custom
loopback connector installed on its Ethernet interface. The detection of the loopback packet
cues the camera to restore Factory Defaults and to revert to the same configuration and
behavior as when the camera left the factory.
The custom loopback connector is described below.
The RJ45 loopback termination ties pin 1 to pin 3, and pin 2 to pin 6. The other pins are not
connected.
427-0030-00-12, version 150
Pin # Signal
1 Transmit +
2 Transmit -
3 Receive +
4 Unused
5 Unused
6 Receive -
7 Unused
8 Unused
January 2012
3—F-Series Camera Configuration
Tied to pin #
3
6
1
N/A
N/A
2
N/A
N/A
3-15