Cable Gland Seal Inserts - FLIR F-Series Installation Manual

F-Series Installation Manual
1.7.3

Cable Gland Seal Inserts

The F-Series camera comes with two 3/4"
NPT cable glands, each with a three hole
gland seal insert. Cables may be between
0.23" to 0.29" od. Typically up to five cables
may be needed. Plugs are required for any
insert hole(s) not being used. The photograph
at the right shows two power cables, an
Ethernet cable, a serial control cable (no
analog video is installed), and two gland seal
plugs.
If non-standard cable diameters are used, you
may need to locate or fabricate the
appropriate insert to fit the desired cable.
FLIR Commercial Systems, Inc. does not
provide cable gland inserts other than what is
supplied with the system.
Note
Insert the cables through the cable glands on the enclosure before terminating and
connecting them. (In general, the terminated connectors will not fit through the cable gland.)
If a terminated cable is required, you can make a clean and singular cut in the gland seal to
install the cable into the gland seal.
427-0030-00-12, version 150
Ground
Lug
Serial Control
January 2012
1—F-Series Camera Installation
Camera Power
Heater Power
Ethernet
gland seal plugs
1-5