Configuration File; Lan Settings - FLIR F-Series Installation Manual

3—F-Series Camera Configuration
3.3.8

Configuration File

Step 1 Click Configuration File. The screen
at the right will be displayed.
Shown at the top of the screen is the
.ini file in a scrollable window. This can
help if you ever need help from a
support engineer.
Step 2 Click Restore in the Factory Backup
and Restore section to reconfigure
the file to the settings sent from the
factory. This file can not be modified
or deleted, so it is always available.
Step 3 In the Customer Backup and Recovery
section, make a backup of your final
custom settings.
Step 4 In the Upload and Download section,
download a copy to a different
network location for safe keeping.
3.3.9

LAN Settings

As the final step in configuring the camera on the bench, you may want to insert a new IP
address appropriate for the local area network receiving the camera. Once you are finished
with this process you typically will no longer be able to access the camera from the same PC
used to see the default IP address.
Step 1 Click LAN Settings. The screen at
the right will be displayed.
Step 2 Enter the Hostname, Gateway, IP
Address, and Netmask that are
appropriate for the local area
network. Click Save.
If you change to a new IP address
and the browser can no longer
communicate with the camera, You
must connect the camera to an
appropriate local area network
(LAN) and connect to the camera
using its new IP address.
3-10 January 2012
F-Series Installation Manual
427-0030-00-12, version 150