Changing Settings; General; Recording Mode; Connections - FLIR E53 User Manual

25

Changing settings

25.1 General

You can change a variety of settings in the camera. You do this on the Settings menu.
The Settings menu includes the following:

• Recording mode.

• Connections.

• Camera temperature range.

• Save options & storage.
• Device settings.
25.1.1 Recording mode
The Recording mode is used to select:
• Single shot: This setting enables single shot mode. In this mode, you save an image by
pulling the trigger.
• Video: This setting enables video recording mode. For more information, see section
20 Recording video clips, page 97.
• Time-lapse: This setting enables time-lapse mode. For more information, see section
19 Programming the camera (time-lapse), page 96.
• Screening: This setting enables screening mode. For more information, see section 21
Screening alarm, page 99.
25.1.2 Connections
• Wi-Fi: This setting defines Wi-Fi networks. For more information, see section 23 Config-
uring Wi-Fi, page 102.
• Bluetooth: This setting defines Bluetooth connectivity. For more information, see sec-
tion 22 Pairing Bluetooth devices, page 101.
25.1.3 Camera temperature range
For accurate temperature measurements, you must change the Camera temperature
range setting to suit the expected temperature of the object you are inspecting.
Available temperature range options are dependent on the camera model. The unit (℃ or
℉) depends on the temperature unit setting, see section 25.1.5 Device settings, page 108.
#T810190; r. AL/47698/47698; en-US
106