Ricoh A163 Service Manual page 70

Mode No.
Used Toner
Counter Clear
53
Developer
Warm-up Setting
54
Paper Length
Limit Setting
55
Copy Number
Limit Setting
56
57 Not Used
to
58
Misfeed Special
59 Recovery Mode
Fixed Paper
Length Special
60
Mode
A163
Function
Clear used toner counter.
Determines the warm-up time to increase the
Q/M of the developer. This warm-up is done
if the fusing temperature is lower than 60 °C
when the main switch is turned on.
Determines the maximum paper length.
Note:
If paper longer than 2000 mm is used, skew
copy, poor fusing, crease copy original
damage might occur.
Determines the maximum copy number.
While the Emergency Stop key is held down,
the main motor and the registration clutch are
energized.
Each time +/-- key is pressed while holding
the Preset Cut key down, the length selected
in SP mode 61 is increased/reduced from the
preset paper size.
4-14
Data
0: Full toner
condition is not
detected
1: Full toner
condition is
detected.
To clear the counter,
input "0" even if "0" is
already indicated.
0: 1 minute
1: 2 minute
2: 3 minute
3: None
(In mm mode)
0: 2000 mm
1: 3600 mm
2: 5200 mm
3: 6800 mm
4: 8400 mm
5: 9999 mm
(In inch mode)
0: 80.0 inch
1: 160.0 inch
2: 240.0 inch
3: 320.0 inch
4: 400.0 inch
5: 480.0 inch
0: 99 sheets
1: 10 sheets
2: 20 sheets
3: 30 sheets
4: 40 sheets
5: 50 sheets
6: 67 sheets
7: 70 sheets
8: 80 sheets
9: 90 sheets
0: No
1: Misfeed Special
Recovery Mode
0: Normal
1: Fixed Paper
Length Special
Mode
FSM