Ricoh A163 Service Manual page 344

SERVICE TOOLS
Mode No.
Roll Feeder Cutting
Length Adjustment
(1,100 mm, Plain
Paper)
45
Roll Feeder Cutting
Length Adjustment
(1,100 mm,
Translucent Paper)
46
Roll Feeder Cutting
Length Adjustment
(1,100 mm,
Translucent Film)
47
Semi-synchro-cut
48 Length Adjustment
Main Motor Speed
Adjustment
49
B047/B048
Function
Adjusts the cutting length of 1,100 mm
in the plain paper mode.
When this value is changed, the values
for SP46 and SP47 are automatically
changed according to the following
table:
Inch versions
SP45 X SP45 X
SP46 X – 1.0 SP46 X – 2.4
SP47 X + 0.8 SP47 X + 0.8
If the settings in SP46 or SP47 exceed
the maximum and/or minimum values,
the maximum or minimum values are
used instead.
Note:
The value for the 1st roll feed can only
be input when the corresponding
indicator is blinking (same for 2nd roll
feed). Use the Function Select Key to
switch between the two indicators.
To adjust the cutting length of 1,100
mm in the translucent paper mode.
Note:
The value for the 1st roll feed can only
be input when the corresponding
indicator is blinking (same for 2nd roll
feed). Use the Function Select Key to
switch between the two indicators.
To adjust the cutting length of 1,100
mm in the translucent film mode.
Note:
The value for the 1st roll feed can only
be input when the corresponding
indicator is blinking (same for 2nd roll
feed). Use the Function Select Key to
switch between the two indicators.
Adjusts the cut length in the semi-
synchro cut mode (B047 copier only).
Changes the main motor speed.
4-6
0: Standard
Meter versions
–10 ← 0 → 10
Shorter
0.1 %/step
0: Standard
When making long
copies, if the main motor
speed is incorrect, rJ98 or
rJ99 error messages will
be displayed. Use this SP
to make the necessary
adjustments.
Data
–50 ← 0 → 50 mm
Longer Shorter
Longer
–9 ← 0 → 11
Slower Faster
SM