Ricoh A163 Service Manual page 350

SERVICE TOOLS
Mode No.
RAM Clear
-1
*Note1:
This counter is not used for the toner density step control (described on page 2-16 in the A163
manual).
*Note2:
For the toner density step control, this counter counts down from 150 (m) to 0 (m) after the
developer initialization. When the developer initialization is done, this counter is set to 150 and after
150 m of copies, the counter stays at 0. If this counter is cleared, the counter is set to 0.
B047/B048
Function
Clears selected data items from the
RAM.
To clear the memory, input the number
of the item you want to delete, then
press the " key.
Note:
If all the memory is cleared (if a
number from 20 to 28 is selected), you
must reenter the roll cutter settings
from the decal attached inside the
upper right cover.
Please refer to page 4-14 for the
default settings for each destination.
(When No. 10 to 26 is selected.)
4-12
Data
0: Not Used
1: Machine Operation
(The memory for
SP67)
2: Copy Length Counter
(SP69 to 75)
3: OPC Counter (SP76)
4: Developer Counter
(*Note1)
(SP77) /
Developer Initialization
Number (SP80)
5: Toner Counter (SP78)/
Toner End Number
(SP81)/Toner Near
End Number (SP82)
6: Counter for toner
(*Note2)
density step.
7: Clear data No.1 to 9
and 53.
8: SC Counter
(SP90 to 91)
9: Jam Counter
(SP85 to 86)
10: Change the settings to
the Japan version
11: Change the settings to
the U.S.A. version
12: Change the settings to
the Europe version
13: Change the settings to
the Asia version
14: Change the settings to
the NRG version
15: Change the settings to
other version 1
16: Change the settings to
other version 2
17: Change the settings to
other version 3
18: Not Used
19: Not Used
20: Clear all the memory
and change the
settings to the
Japanese version
SM