Ricoh A163 Service Manual page 53

[K]
[A]
[C]
[B]
3. Attach the roll paper arms [A] to the cutter guide [B]. (Install each arm pin [C]
into each cutter guide hole [D]. Position the cutter guide pin [E] in the lower
slot of the roll paper arm [F].)
4. Install the cutter guide on the roll shaft holder [G].
5. Slide the roll paper shaft [H] into the roll paper.
6. Fit the roll flanges [I] onto the roll paper shaft (both ends).
7. Push the roll flanges [I] inside to fix the roll paper position.
8. Set the roll paper shaft on the roll shaft holder.
9. Set the paper between the cutter guide stay [J] and slide shafts [K].
10. Check the roll cutting rail operation.
FSM
[J] [G]
[E]
[H]
[D] [C] [F]
[H]
3-15
[G]
[A]
[I]
[I]
A163