Ricoh A163 Service Manual page 343

Mode No.
Roll Feeder Cutting
Length Adjustment
(300 mm, Plain
Paper)
42
Roll Feeder Cutting
Length Adjustment
(300 mm,
Translucent Paper)
43
Roll Feeder Cutting
Length Adjustment
(300 mm,
translucent Film)
44
SM
Function
Adjusts the cutting length of 300 mm in
the plain paper mode.
When this value is changed, the values
for SP43 and SP44 are automatically
changed according to the following
table:
Inch versions Meter versions
SP42 X SP42 X
SP43 X SP43 X – 0.4
SP44 X + 0.5 SP44 X + 0.5
If the settings in SP43 or SP44 exceed
the maximum and/or minimum values,
the maximum or minimum values are
used instead.
Note:
The value for the 1st roll feed can only
be input when the corresponding
indicator is blinking (same for 2nd roll
feed). Use the Function Select Key to
switch between the two indicators.
To adjust the cutting length of 300 mm
in the translucent paper mode.
Note:
The value for the 1st roll feed can only
be input when the corresponding
indicator is blinking (same for 2nd roll
feed). Use the Function Select Key to
switch between the two indicators.
To adjust the cutting length of 300 mm
in the translucent film mode.
Note:
The value for the 1st roll feed can only
be input when the corresponding
indicator is blinking (same for 2nd roll
feed). Use the Function Select Key to
switch between the two indicators.
4-5
SERVICE TOOLS
Data
0: Standard
–9.9 ← 0 → 9.9 mm
Longer Shorter
B047/B048