Ricoh A163 Service Manual page 68

Rev. 12/22/95
Mode No.
Optional Paper
Size Setting
*23
to
*32
33 Not Used
to
34
All Indicators On
*35
New Developer
Initialization
36
37 Not Used
Release Fusing
38 Unit Service Call
39 Not Used
Roll Feeder
40 Identification
Roll Feeder
41 Speed Setting
(Factory Use)
Roll Feeder
Cutting Length
42
Adjustment (300
mm, Plain Paper)
Roll Feeder
Cutting Length
43 Adjustment (300
mm, Translucent
Paper)
Roll Feeder
Cutting Length
44 Adjustment (300
mm, translucent
Film)
A163
Function
Up to 10 different paper size can be stored
from 23 to 32. If "19" is selected in SP No.
22, this data is used as fixed paper size when
the "Preset Cut" key is pressed.
Turns on all the indicators on the operation
panel when the Roll Feed Select key is
pressed.
Carries out the new developer initialization for
5 minutes. The machine counts down the
remaining time on the display. After the
initialization, the machine automatically
adjusts the toner sensor output to 4.0 ± 0.1V.
During the toner sensor adjustment, "Adj" is
displayed. When the adjustment is
completed, the machine automatically returns
to normal operating mode.
Recovers from the fusing unit SC condition.
After it has been recovered, the machine
returns to its initial (power on) condition.
Identify the roll feeder installation.
To adjust the paper feed speed of the roll
feeder.
To adjust the cutting length of 300 mm in the
plain paper mode.
To adjust the cutting length of 300 mm in the
translucent paper mode.
To adjust the cutting length of 300 mm in the
translucent film mode.
4-12
Data
UdEF: Undefined
0: No
1: All indicators on
If the initialization is
canceled before
returning to the
normal operating
mode, do it again
from the beginning. If
the machine fails to
adjust the toner
sensor output, "E=11"
is indicated.
0: Release SC
1: SC condition
0: No
1: Roll Feeder
Installed
0: Standard
--50 ← 0 → 50
Faster Slower
0: Standard
--9.9 ← 0 → 9.9 mm
Longer Shorter
FSM