Continuous (Normal) Recording - Santec SanStore-4EM User Manual

6.5 Continuous (normal) recording

The recorder has a number of default factory settings. Hence immediately after its installation
the recorder is ready to record (press the [REC] button to start the recording). By default,
audio alarm and motion detection are turned off.
Procedure:
Use the direction buttons [
confirm.
Use the direction buttons [
Use the [ - + ] buttons to change the values.
ITEM
USE Enable or disable the recording per camera.
Specify the picture quality for each camera.
QUALITY
ULTRA  SUPER  HIGH  MIDDLE LOW
Select the recording speed for each camera.
RATE
Recording resolutions is set under system setting  General
Set the audio recording to ON or OFF.
The audio data is always recorded in real time unlike the video data that can be
AUDIO
recorded in various modes including real time. There may be a slight delay in
synchronisation of the audio to the video data.
Set the motion recording to ON or OFF. The camera does not record under normal
MOTION
conditions. (cf. chapter 6.4)
Note:
Press the [DISPLAY] button at the beginning of each item to copy all settings to the other
channels.
_________________________________________________________________________________
User manual SanStore-4EM / SanStore-8EM
] to select „recording". Then press [ENTER] to
] to select the camera you wish to configure.
ADJUSTMENT
- 32 -