Alarm Recording; Recording Setup - Santec SanStore-4EM User Manual

6.6 Alarm recording

Please verify the alarm record settings prior to starting the alarm recording. Please note that
the alarm recording is independent of any recording modes. Alarm record starts after the
alarm recordind has been enabled.

6.6.1. Recording setup

Use the direction buttons [] to select the "ALARM" menu. Then press the
1.
[ENTER] button to display "Alarm Record Setup".
Use the left/right buttons [] to select a tab menu (
2.
Use the direction buttons [] to select the camera you wish to configure.
3.
Use the [-, +] button to change the value.
4.
ITEM
USE
QUALITY
RATE
AUDIO
MOTION
Note:
Press the [MENU] button at the beginning of each item to copy all settings to the
other channels.
Press [ENTER] to save the changes and to exit the menu.
5.
Press [CANCEL] to exit the menu without saving the changes.
_________________________________________________________________________________
Enable or disable the recording per camera.
Specify the picture quality for each camera.
ULTRA  SUPER  HIGH  MIDDLE  LOW
Select recording rate of each camera when an alarm is triggered.
Set the audio recording to ON or OFF.
Specify the type of alarm input device.
User manual SanStore-4EM / SanStore-8EM
ADJUSTMENT
- 34 -
).