Table of Contents
Advertisement
User manual SanStore-4EM / SanStore-8EM
ITEM
SYSTEM ID
AUTO KEY LOCK
KEY TONE
KEYPAD MODEL
RECORD SIZE
PB DEINTERLACE
RUN ON BOOT
PASSWORD ON
_________________________________________________________________________________
To select the DVR to be controlled with the remote control, press and hold the
DVR ID button. While holding the DVR ID button, press the appropriate DVR
ID number. For example, enter 05 for DVR ID 05, enter 43 for DVR ID 43, and
so on.
Set the ID on the remote control to "00" to control DVRs at the same time,
irrespective of whatever DVR ID they are.
The DVR locks all the buttons after three minutes of inactivity like a
screensaver. The buttons can be unlocked with the user password. Default is
"OFF".
By default, the DVR emits a beep every time a button is pressed. Set the key
tone to "off" to turn the button beep off. Default is "ON"
Select the joystick control and the Baud rate.
CIF : The DVR records each camera individually and then multiplexes them.
Each channel records at a field resolution of 360*240(360*288).
Field :The DVR records each camera individually and then multiplexes them.
Each channel records at a field resolution of 720*240(720*288).
Frame: 720*480(720*576)
ON: Reduces image flickering but less picture quality.
OFF: Better picture quality for still image but having flickers for moving picture.
If you tick "Normal Recording", the unit will save the previous recording setup
value after rebooting. For example, if you shutdown the DVR in this "Normal
Recording" mode, the unit will still be in recording mode when you turn on the
DVR again. And if you choose "Schedule Rec", the unit will be in schedule
recording mode.
if you choose "OFF", the password window will not be shown except for
"power off", "service menu", "recording stop", schedule recording" and "stop".
ADJUSTMENT
- 47 -
Advertisement
Table of Contents
