Removing And Replacing Gsc Cards; Preliminary Requirements; Removal - HP 743 Service Handbook

Removing and Replacing GSC Cards

This section provides step-by-step instructions for removing GSC cards from your
Model 743.

Preliminary Requirements

Perform the following steps before you remove a GSC card:
1 Remove the 743 from it's chassis. (Removing and Replacing the 743 Board Computer,
page 5-9 )

Removal

Follow these steps to remove a GSC card:
1 Working from the back of the Model 743 Board Computer, the GSC graphics cards are
in either the right-hand or center position shown in Figure 5-4.
2 Remove the two M2.5X5 screws that hold the card to the front panel extension plate.
Removing and Replacing GSC Cards
Field Replaceable Units
5-15