Interactive Testing Menu; Interactive Tests - HP 743 Service Handbook

Interactive Testing Menu

Once in the Boot Console Handler Mode, at the Main Menu, select Interactive Tests. This
menu, shown below, allows a user to run selected tests and allows access to the debugger
environment. Table 4-2 lists the types of test you can run from the Interactive Test menu.
==== INTERACTIVE TESTING =====================
Key Operation
--- -----------------------------------------
1 CPU S.S.
2 HIL INIT
3 GRAPHICS 1 INIT
4 GRAPHICS 2 INIT
5 GRAPHICS 3 INIT
6 GRAPHICS 4 INIT
... .........................................
00 Previous Menu
44 Enter Debug Environment
77 Reset the System
----------------------------------------------
To run a test, Press Key, then press [Enter/Return]
Table 4-2
Test
CPU S.S.
HIL INIT
GRAPHICS n
When an interactive test is run, the pass/fail message appears at the bottom of the menu.
For more information and examples on Interactive Tests, see the section "Interactive Test
Menu" in this manual.

Interactive Tests

Tests the CPU super scalar operations
Initializes and tests the HIL interface. This test support the
Model 748i VME system's HP-HIL connector used with its
EISA converter board.
If this is the console keyboard, the test will not run, but will
report "passed".
If the hardware is missing, the test reports as "passed." If the
special graphics interface is the console, the test will not run, but
reports as "passed".
Interactive Testing Menu
Function
Troubleshooting
4-13