Replacement - HP 743 Service Handbook

Front
Panel
screws
M2.5X6
screws
M2.5X12
screws
Figure 5-12
2 Remove the four DIN connector M2.5X12 screws from the bottom of the system board.
3 Remove the two small screws at each end of the graphic connector on the front panel.
4 Remove the HCRX board from the computer by lifting it straight up from the centered
connector.

Replacement

To replace an HCRX board, reverse the steps in the procedure for removing a board.
Removing and Replacing an HCRX Graphics Board
HCRX Board Fasteners
Field Replaceable Units
5-27