Field Replaceable Units
Removing and Replacing the Front Panel Extension
Removing and Replacing the Front Panel Extension
This section provides step-by-step instructions for removing the front panel extension
from your Model 743.
Preliminary Requirements
Perform these steps before removing the front panel extension from the Model 743:
1
Remove the 743. (Removing and Replacing the 743 Board Computer, page 5-9 .)
2
Remove any GSC cards. (Removing and Replacing GSC Graphics cards.)
3
Remove the Expansion adapter or HCRX board.
Removal and Replacement
Follow these steps to remove the front panel extension:
1
Remove the M2.5X6 screws which hold the panel extension to the front panel as shown
in Figure 5-13.
Figure 5-13
2
Pull the front panel extension up and off the front panel.
5-28
Front Panel Extension Fasteners