3
Remove the rear door and cover. See
4
Remove the power supply. See
5
Remove the power supply shield. See
6
Remove the duplex. See
7
Disconnect the cable JDUPPI 1 from the controller board.
8
Remove the two screws (A), and cut the cable near the frame to detach the sensors.
9
Remove the other half of the cable from the printer.
Installation note: Route the cable using the new path, and secure it with a cable tie (A).
"Rear door and cover removal" on page
"Power supply removal" on page
"Power supply shield removal" on page
"Duplex removal" on page
A
Repair information
191.
193.
195
4514-420, -430
207.
192.