Memory Allocation Program - Sam4s ER-5200M Operator's And Programming Manual

Memory Calculation Example
The default memory allocation is shown below as a calculation example:
Variable
PLU
Clerks
Groups
Guest Check
Lines per Soft Check
Mix & Match
Total Used
Total Available

Memory Allocation Program

Once you have determined the memory variable you wish to set, you can set them in the memory
allocation program. If you attempt to allocate more options than memory, the message "MEMORY
ALLOCATION SIZE OVER" will print on the receipt and journal.
4. Enter the desired allocation.
5. Repeat from step 3 to allocate another area, or press the CASH key to finalize the program.
82 • S-Mode Programming
Bytes per
unit
78
1705
47
494
38
20
1. Turn the control lock to the S position.
2. To Allocate Memory, enter 6 0 and press the SBTL key.
6 0 SBTL
3. Refer to the chart below and enter a digit to represent allocated area and press the
X/TIME key.
X X/TIME
Note for the CHECK TYPE
entry: enter 0 for soft check
or enter 1 for hard check.
If the allocation is accepted, the printer will print the new allocation. If the allocation is not
accepted, the message "ALLOCATION OVER . . ." will display.
CASH
Default Total
Quantity
1000 78,000
15 25,575
20 940
20 9,880
50 x 20 38,000
(guest check
quantity)
25 500
152,895
187,144
X Allocated Area
1 PLU
2
CLERK
3 GROUP
4
CHECK#
5 SOFT CHECK LINES
6 CHECK TYPE : Hard(1), Soft(0)
7 MIX & MATCH
CASH
ER-5200M/5240M Electronic Cash Register
The total memory
used must be less that
the total memory
available