Preparing Procedures - JTS US-1000D-TH Instruction Manual

group digit starts flashing, after these procedure please press "SET" button again
till frequency starts flashing then press "SET" button till sensitivity displaying
please press "SET" button to start the lock-on setting. Press "UP" button for
lock-on mode and "DN" button for lock-off mode. Re-press "SET" button the
lock function will store.
5.2 Group displayed :
Press "SET" button three sec. till group digit show up, re-press "SET" the
frequency. Starts flashing. Press "SET" button again till "MHz" show up,
re-press "SET" button till sensitivity displaying, press "SET" button till
"Loc OFF" starts flashing then you can proceed the lock-on setting. Press
"UP" button for lock-on mode and "DN" button for lock-off mode. Re-press
"SET" button the lock function will store.
6. Relieved Lock-on :
Press "SET" button three sec. till "Loc On" show up, then press "DN" button
plus "SET" button to store the lock-on relieved.
7. Press any button the display shows "Loc On" during lock-on model.
And it will not disappeared either electric off.
PT-990B-TH(mi)
5-3 Body-pack Transmitter
(1.) Turning the transmitter on/off
The on/off switch is located on the top of the transmitter.
(2.) Inserting and changing the battery
1. The battery tray is located on the back of the transmitter.
2. Hold on to both belt clip buttons to release it.
3. Insert 2 pieces of UM-3 1.5V batteries. Remember to match correct polarity.
4. Directly slide the belt clip back.
(Figure 5)
(Figure 6)
~12~

6. Preparing procedures

6-1 ( US-1000D-TH Receiver )
(1.) Setting the rubber pad
Four self-adhesive rubber pads are provided to ensure the stability.
They are to be placed on the bottom side of the receiver.
(2.) Connecting the antennas
The user-friendly
socket for effortless connection. Connect two antennas on the
back of the receiver and align them upward.
(3.) Connecting the main unit
Plug in the DC connector on the back of the receiver
(DCV INPUT).
(4.) Connecting the amplifier/mixer console
Plug in the amplifier/mixer console to the
(AF OUT UNBAL / BAL ) sockets.
(5.) Turning the receiver on/off
Turn the receiver on by pressing the (POWER)
button.
(6.) Adjusting the AF output level
Use the AF output level control located on the front side of the receiver to adjust
the AF signal level that appears at output.
(Figure 7)
US-1000D-TH
antenna comes with easy mount on
~13~
AF OUTPUT
AF OUTPUT BALANCED
DCV INPUT UNBAL .
Freq. Range:
Serial No.:
12-18V/500mA ANT. 2 ANT. 1
ANT.1 / ANT.2
AF OUTPUT
BALANCED
AF OUTPUT
DCV INPUT UNBAL .
Freq. Range:
Serial No.:
ANT. 2 ANT. 1
12-18V/500mA
DCV INPUT
AF OUTPUT
BALANCED
AF OUTPUT
DCV INPUT UNBAL .
Freq. Range:
Serial No.:
12-18V/500mA ANT. 2 ANT. 1
AF OUT UNBAL / BAL
power
AF output level