Preparing Procedures Of Condenser Microphone & Accessories - JTS US-1000D-TH Instruction Manual

6-4 Press the SET button to select between frequency and sensitivity.
Mh-8990
1. Frequency adjusting
Press the UP or DOWN button to adjust the setting of a menu.
-Hold SET button for 3 seconds to activate frequency.
-Once you see "MHZ" blanking, you are ready to select your desired frequency
by using UP and DOWN buttons.
-Press the SET button again to store your changes.
2. Sensitivity adjusting
-Press the SET button twice to select sensitivity. Lasting for 3 seconds at the first
press, then 1 second for the second press, and the display appears "SenSit".
-Use UP and DOWN buttons to adjust changes.
-Finally press SET button again to store your changes.
UP button to activate "Lock mode"
-Hold on to UP button for 3 seconds to activate "Lock mode", press again to unlock.
(Prevent accidental programming or switching off)
~14~
7. Preparing Procedures Of Condenser
Microphone & Accesories
(1) With CM-201/CM-501 Lavalier microphone
Attach CM-201/CM-501 to clothing, tie, lapel, where is the suitable place of sound
pick-up.
Plug the mini XLR on the microphone cable into the "MIC. IN" on the body-pack
transmitter. (Figure 8)
(2) With CM-204/CX-504 Headset microphone
Put the neck-frame behind your neck meanwhile fix the temples on your ears.
Adjust the gooseneck to aim the microphone toward the suitable sound source,
which is about 1.5-2 inches distance from your mouth. Plug the mini XLR on the
microphone cable into the "MIC. IN" on the body-pack transmitter. (Figure 9)
MIC IN
(Figure 9)
(3) Dual Rack Adaptor set
The dual rack adaptor is available to unify the half rack
space into a standard EIA size with single or dual units.
Basic operation
1. Frequency
adjusting
-Hold SET button for 3 seconds to activate frequency.
-Once you see "MHZ" blanking, you are ready to select your
desired frequency by using UP and DOWN buttons.
-Press the SET button again to store your changes.
(Figure 8)
UP
DOWN
~15~
SET