Download  Print this page

JTS US-8010D Instruction Manual

Us-8010d series
Hide thumbs

Advertisement

US-8010
US-8010D Series
US-8010D/US-8010/Mh-700D/Mh-700/Mh-800
PT-900BD/PT-900B
Instruction Manual
59506-041-08

Advertisement

Table of Contents
loading

  Related Manuals for JTS US-8010D

  Summary of Contents for JTS US-8010D

  • Page 1 US-8010 US-8010D Series US-8010D/US-8010/Mh-700D/Mh-700/Mh-800 PT-900BD/PT-900B Instruction Manual 59506-041-08...
  • Page 2: Table Of Contents

    5-5 Body-pack Transmitter // PT-900B / PT-900BD 5-6 Installation of Condenser Microphones Thank you for choosing the JTS wireless system. In order to obtain the best efficiency from the system, 6. Recommendation you are recommended to take a few minutes to read this instruction manual carefully.
  • Page 3: Important Caution

    Do not leave the device in a place neither with high temperature nor high humidity. • Always do not handle the power cord with wet hands! • Model No........US-8010D / US-8010 Keep the devices away from fire and heat sources. Frequency Preparation..Crystal Carrier Frequency Range 600~960 MHz Frequency Stability....
  • Page 4: Body-Pack Transmitter // Pt-900B / Pt-900Bd

    3-3 Body-pack Transmitter Headset Microphone Model No.......... PT-900 / PT-900BD Model No....... CM-214 CM-214U CM-214UL Frequency Preparation.... Crystal Connector....... 801C4 4P Mini XLR 801C3 (3P Mini XLR) Carrier Frequency Range..600~960 MHz (4P Mini XLR) 801C4 (4P Mini XLR) RF Outputs........10mW 801CS (3.5 stereo plug) Stability.........
  • Page 5: Part Identification & Accessories

    4. Parts Identification & Accessories Ear-hook Microphone 4-1 Receiver // US-8010D / US-8010 Model No....... CM-801/CM-804i CM-8015/CM-825i Power On/Off Connector......801C4 (4P Mini XLR) 801C4 (4P Mini XLR) RF indicator Option Connector... 801C3 (3P Mini XLR) 801C3 (3P Mini XLR) AF indicator 801CS (3.5 stereo plug)
  • Page 6: Body-Pack Transmitter // Pt-900B / Pt-900Bd

    4-3 Body-pack Transmitter // PT-900B / PT-900BD Headset Microphone // CM-214 / CM-214U / CM-214UL / CM-235 / CX-504 Mic. input Gooseneck Power On/off switch Adjustable headband Power Indicator Headband Antenna 4 Pin Mini XLR AF level control Windscreen Battery tray Battery tray cover Carry case Belt-loop...
  • Page 7 Ear-hook Microphone // CM-801 / CM-804i / CM-8015 / CM-825i Compatible Instrument Microphone // CX-500 / CX-500F / CX-520 CX-508W / CX-516W Boom Adjustable Headband Adjustable ear hook Detchable Cable Gooseneck Cable Clip CM-801 Clip Windscreen Bracket 4 Pin Mini XLR Volume Control Option 3 Pin Mini XLR...
  • Page 8: Accessories

    5. Preparing Procedures & Basic Operation 5-1 Receiver // US-8010D / US-8010 4-5 Accessories AC/DC adaptor (1) Audio Output Connector Switching Power Supply(100V~240V , 50~60Hz) The receiver equipped with both balanced XLR output and unbalanced φ 6.3mm jack output; Linear Power Supply (220V , 50Hz) Option you can choose the proper way for using.
  • Page 9: Rack Mounting

    5-2 Rack Mounting 5-4 Handheld transmitter // Mh-700D / Mh-700 / Mh-800 (1) Before mount receivers onto DR-900 rack adaptor, please release any cables from the rear of (1) Mh-700D & Mh-700 & Mh-800 Handheld Transmitter the receiver. 1. Turn the microphone ball grille counter-clockwise ( Figure 1), press both release knobs to remove the (2) Turn over receiver and DR-900 rack adaptor simultaneously, there are 4 threaded holes each battery tray from the mic.
  • Page 10: Body-Pack Transmitter // Pt-900B / Pt-900Bd

    (3) Instrument Microphones (2) Wearing the Body-pack transmitter The system is compatible with JTS various instrument microphones. The carry case allows body-pack transmitter to be attached on performer’ s belt, place the For detail please refer to user’ s manuals of these microphones.
  • Page 11: Recommendation

    6. Recommendation (4) Ear-hook Microphone (1) In order to achieve the optimum reception condition and also extend the operating distance, 1. Lightweight Dual Ear Hook Microphone please leave a “open space” between the receiver and transmitter. Try on whether the headset is fit. (2) Keep the devices away from the metal objects or any interference sources, at least 50 cm.
  • Page 12: Important Notice

    7. Important Notice (1) JTS offers wireless systems in a selection of bands that conform to the different government regulations of specific nations or geographic regions. These regulations help limit radio frequency (RF) interference among different wireless devices and prevent interference with local public communications channels, such as television and emergency broadcasts.

This manual is also suitable for:

Us-8010Mh-700dMh-700Mh-800Pt-900bdPt-900b