Note For Installation Place - Sharp MX-M350 Service Manual

2. Note for installation place

Improper installation may damage this product. Please note the
following during initial installation and whenever the machine is
moved.
1) The machine should be installed near an accessible power
outlet for easy connection.
2) Be sure to connect the power cord only to a power outlet that
meets the specified voltage and current requirements. Also
make certain the outlet is properly grounded.
• For the power supply requirements, see the name plate of
the main unit.
3) Do not install your machine in areas that are:
• damp, humid, or very dusty
• exposed to direct sunlight
• poorly ventilated
• subject to extreme temperature or humidity
changes, e.g., near an air conditioner or heater.
4) Be sure to allow the required space around the machine for
servicing and proper ventilation.
31-1/2"
(80cm)
3. Unpacking procedure
1) Release the joint, and remove the packing case.
2) Remove the top pad, and open the electrostatic polyethylene
bag.
Check the following items are included in the package.
MX-M350N/M450N
Operating Manual
(Common/Copier, Administrator guide (System settings))
Web manuals (Printer)
(Network Scan)
Installation manual (PCL/PS)
11-13/16" (30cm)
23-5/8"
(60cm)
23-5/8" (60cm)
MX-M350U/M450U
–
MX-M350/M450 N/U UNPACKING AND INSTALLATION 6 - 2
MX-M350N/M450N
CD-ROM (Printer)
Maintenance card/Maintenance case (Except UK)
Warranty Registration (UK only)
Delivery/installation report (Europe only)
MSDS card (North America/UK only)
Warranty (Australia only)
Scanner key sheet (Local area only)
Dust cover (Local area only)
3) Remove the cushioning materials from the right and left of the
front side.
4) Remove the locking tape from the right and left sides of the
tray.
Then, Remove the top of the carton and lower the plastic bag
covering the machine while the machine is still on the carton
base.
5) Remove the packing tape from the paper tray, pull out the
paper tray until it stops and remove it by tilting it upward.
6) One person must lift by the empty front tray pocket with the
right hand and steady the machine with the left hand placed at
the upper left of the machine.
The other person must lift with the right hand by using the lift-
ing recess in the rear of the machine and also steady the
machine with the left hand as shown in the illustration.
Note: The center of gravity of the machine lies in the left side
when viewed from the Back of machine. When lifting the
machine, be careful not to drop it.
MX-M350U/M450U
Front side
Rear side