Unpacking And Installation - Sharp AR-TE3 Service Manual

[4] UNPACKING AND INSTALLATION

1.AR-DU3
<Before installation>
•For installing AR-DU3, an optional desk (multi purpose drawer, stand/3 x
500 sheet paper drawer or stand/MPD & 2000 sheet drawer) must have
been installed.
•Ensure that the front mounting plates and the rear mounting plates
included with the optional stand/paper drawer are securely attached.
1) Turn off the main switch of the main unit of the printer.
Turn the main switch located on the front side of the main unit of the
printer to the "OFF" position.
Then, remove the power plug of the main unit of the printer from the
outlet.
2) Remove the left side cover of the main unit of the printer.
Unlock the lock release lever of the main unit of the printer and then
pull out the left door.
Slide the two upper covers up to remove them. Remove the lower
cover by inserting a flat-blade screwdriver at three locations (
shown in the illustration.
Then, close the left door.
Top covers
Left door
Lower cover
Lock release lever
3) Attach the duplex module to the main unit of the printer.
<1>Hang the hooks located at the upper part of the duplex module on
the openings of the left door of the main unit of the printer.
<2>Push the lower part of the duplex module to insert the positioning
bosses securely into the main unit of the printer.
<3>Tighten the two screws built in the duplex module.
Hook
3
3
2
Positioning boss
Duplex module
OFF
" "
Hook
1
1
2
Positioning boss
AR-DU3/DU4/TE3 UNPACKING AND INSTALLATION-1
4) Connect the harness to the main unit of the printer.
<1>Remove the screw that fixes the harness cover of the main unit of the
printer and then slide the harness cover up to remove it.
<2>Process the harness cover as shown in the illustration.
Harness cover
Cut out.
<3>Connect the connector of the relay harness of the duplex module to
the white connector of the PCU PWB of the main unit of the printer.
<4>Insert the two snap bands to the locations shown in the illustration
and fix them.
<5>Use the screw packed together to fix the earth harness.
)
Relay harness
connector
Snap bands
4
<6>Reattach the harness cover to its original position and fix it with the
removed screw.
Relay harness
Screw
Harness cover
White connector
PCU PWB
3
4
5
Screw
Ground harness
Harness cover
Screw