ashtech Z-Surveyor Operation And Reference Manual page 61

•
Even if all the SITE characters are letters, the display will still go to the accept/refuse menu. You will
need to refuse before being able to enter a new SITE. If you accept, the same SITE will be used for
the new point.
• Antenna Height (ANT HT:**.****m)
Sets the height of the GPS antenna
• Survey Status (STATUS)
STATUS
RTK BASE
• SITE (SITE:****)
Sets the four character SITE name.
• Antenna Height (ANT HT:**.****m)
Sets the height of the GPS antenna
• Antenna Radius (ANT RAD:*.****m)
Sets the radius of the GPS antenna.
Operations
epoch counter value (at the rate of the recording interval set in the
SURVCONF menu).
Incremented SITE (Site:****?)
Once the log counter reaches 0 (when enough epochs have been
recorded for the current site), the receiver beeps and the B-file reverts to
????. The display automatically increments the SITE while waiting for
the user to set up at the new point. The user can then accept or reject the
proposed SITE.
The SITE is automatically incremented only if the last character (on the
right) is a number. When this number reaches 9, it rolls back to 0. If the
character on the left is also a number, it gets incremented, and so on.
The characters which are not incremented and the ones on the left of the
1st character which is not a number, are ignored (the same SITE will be
used for the new point).
is a submenu with information which can be found in Table 4.3
49