Base System Setup - ashtech Z-Surveyor Operation And Reference Manual

Base System Setup

You must have RTK Base option [K] installed on the receiver and if RTCM 18/19 is
to be used, the RTCM Base option [B] also.
1.
2.
3.
74
Place the receiver in RTK Base mode
From the main menu press ↑ <2 seconds until
a.
selected, press ↓ >2 seconds to enter the submenu.
b. With
SURVCONF
c. Within the
SURVCONF
is selected.
is not displayed, press ↓ <2 seconds to place the receiver in
d. If
RTK BASE
edit mode.
Press ↑< 2 seconds repeatedly until
e.
Press ↑+↓ <2 seconds to accept the parameter setting (pressing ↑+↓ >2
f.
seconds cancels the parameter setting).
Select output port and base data type to send.
Press ↑< 2 seconds repeatedly until
a.
Press ↓ >2 seconds to place the receiver in the
b.
Press ↑ <2 seconds to select the port through which the base data will be
c.
sent.
Press ↓ <2 seconds to enter the edit mode.
d.
Press ↓ <2 seconds to select
e.
49).
Press ↑+↓ <2 seconds to accept the parameter setting (pressing ↑+↓ >2
f.
seconds cancels the parameter setting).
Enter a base position
From the main menu press ↑ <2 seconds until
a.
selected.
b. With
SURVEY:RTK BASE
submenu.
c. Within
SURVEY:RTK BASE
displayed.
Press ↓ >2 seconds to enter
d.
Press ↓ <2 seconds to edit the latitude.
e.
Press ↑ or ↓ <2 seconds to change 1st digit of latitude.
f.
Press ↑+↓ <2 seconds to accept new digit (Press ↑+↓ >2 seconds to
g.
cancel parameter setting).
h. Repeat steps f. and g. for all the digits of the latitude.
submenu, press ↑< 2 seconds repeatedly until
RTK BASE
PORT/TYPE
OFF/DBEN/RTCM
selected, press ↓ >2 seconds to enter the
press ↑ <2 seconds until
submenu.
BASE POS
Z-Surveyor & Z-FX Operation Manual
is selected.
SURVCONF
is selected.
is selected.
submenu.
PORT/TYPE
. ("RTK BASE" on page
is
SURVEY:RTK BASE
is
BASE POS
MODE