Table of Contents
Advertisement
Getting Started
This chapter describes receiver operations available through the front panel.
Memory Card
This section applies only to the Z-Surveyor.
While you may use the Z-Surveyor without a memory card, one is required for internal
data storage.
Installation
Perform the following steps to properly insert the PCMCIA card.
1.
Orient the Z-Surveyor so that you are looking at the front panel.
2.
Open the memory bay door on the front of the Z-Surveyor.
3.
Orient the PCMCIA card so the arrow on the label is on the bottom side of card
and pointing towards the memory card slot.
Getting Started
PCMCIA LED
Figure 3.1: Opening Memory Bay Door
3
PCMCIA Card Slot
Slot Filler
29
Hide quick links:
Advertisement
Table of Contents
