Internal Battery; Installation; Figure 3.4: Pcmcia Card Removal - ashtech Z-Surveyor Operation And Reference Manual

4.
5.
6.

Internal Battery

This section only applies to the Z-Surveyor.
Using the Z-Surveyor in a field environment requires a battery (internal and external
models are available—the receiver will default to the external battery if it is
connected). This section covers only the internal battery.

Installation

1.
32
Depress the PCMCIA ejection lever (the one pointed towards the LED
display) to eject the card from its slot (the slot closest to the top of the unit
when viewed right-side-up from the front).
While holding the memory card bay door open, grasp the PCMCIA card by
the sides with thumb and forefinger and remove it. Alternatively, grasp the
tab located on the PCMCIA card and pull the card out.

Figure 3.4: PCMCIA card removal

Close the memory card bay door.
Orient the Z-Surveyor so that you are looking at the front panel. Refer to
Figure 2.1 for a depiction of the Z-Surveyor front panel.
Z-Surveyor & Z-FX Operation Manual