Smartrunk It ™ And Conventional Modes; Iitm Operation; Smartrunk Ii™ Operation - Icom IC-F30 Instruction Manual

OPTIONAL SmarTrunk IITM OPERATION
11
• SmarTrunk
IITM
and
conventional modes
When the optional UT.. 105 is installed, you can communicate
using conventional channels or SmarTrunk IITM channels.
Select a channel bank for SmarTrunk IITM before trunking op..
eration.
Rotate the channel selector or push [P] one or more times to
select a channel bank for conventional channels or
SmarTrunk
IITM
channels.
• Scanning starts when a channel bank for SmarTrunk II™ is se-
lected.
• Contact your dealer for channel bank details.
• SmarTrunk
IITM
operation
These features are enabled by a dealer or system operator
and may not be available in your system. Contact your dealer
for details.
<>
Placing a telephone call
Enter the phone number followed by [1], [*].
• A high-pitched beep indicates that the number is accepted.
• When the called party answers, push [PTT] to talk, and release it to
listen.
<>
Calling another local system subscriber
Enter the subscriber number followed by [3], [*].
• A high-pitched beep indicates that the number is accepted.
• You hear ringing, then two short beeps when the subscriber an-
swers.
• If the other subscriber is on another call or out of range, you hear a
fast busy signal and the call terminates automatically.
<>
Receiving a call
When you hear ringing, push
[*l
to answer.
• For a group call, you hear a short ring followed by two short beeps.
You do not have to answer a group call to hear it over the air.
<>
Terminating a call
After completing a call, push [#] to disconnect (hang up).
Important: If one person in the conversation terminates a
call, all participants will be cut off.
<>
Last number redial
Push
[*1, [*1
to automatically redial the last number called.
• A high-pitched beep indicates that the number is accepted.
<>
Memory speed-dialing
To automatically dial a commonly used number from memory:
Push [P] followed by the memory location (0-9).