I Transmitting A Call - Icom IC-F70T Instruction Manual

I Transmitting a call

A total of 3 ways for code selection are available—selecting
the call code from memory, entering the call code from the
keypad and calling back from the queue channel record.
D D Using call memory
q While in the standby condition, push [P1] (Digital) to enter
the call code memory channel selection mode.
• " " appears.
w Push [Up] or [Down] to select the desired call code.
e Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and "WAIT" is displayed during each call. However, an
error beep sounds and
answer back is received after the calls.
r Push [PTT] to transmit; release to receive.
t Push [P4] (Moni(Audi)) to send the 'Clear down' signal.
Appears
X
is displayed when no
"FAILED"
D D Calling back from the queue channel
q While in the standby condition, push and hold [P1] (Digital)
for 1 sec. to enter the queue memory channel selection
mode.
w Push [Up] or [Down] to select the desired record.
e Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and "WAIT" is displayed during each call. However, an
error beep sounds and
answer back is received after the calls.
r Push [PTT] to transmit; release to receive.
t Push [P4] (Moni(Audi)) to send the 'Clear down' signal.
BIIS OPERATION
X
is displayed when no
"FAILED"
4
4
21