Enable Digital Output Alarm
The Digital Output Alarm can activate the digital output devices while it
is detecting an alarm event. Follow the instructions below to set the Digital
Output Alarm.
1. Select alarm types of cameras, DI, Disk Full, Disk Failure, or No signal.
2. Select Alarm Trigger Period.
3. Click Dout tab.
4. Select a Dout and enable it.
5. Select the "Delay" time. (0~999 seconds.)
6. Under the "Duration" there are settings of 0 to 999 seconds to choose from.
A setting of 0 seconds means permanent triggering.
7. Click "Add" button to add this configuration in the below list.
8. Click "Apply" or "OK" to save the configuration.
Users can also modify alarm actions by selecting an Action and change
its setting, then click "Modify" to configure it. To delete an alarm action, just
choose an Action and then click "Del" button to delete it.
Chapter 6
Pic6-9: Dout Alarm
39