Enable Message Alarm
The Message Alarm may show additional information at the time of
detecting the alarm condition. Follow the instruction below to set the Alarm
Message.
1. Select alarm types of cameras, DI, Disk Full, Disk Failure, or No signal.
2. Select Alarm Trigger Period
3. Click Message tab
4. Click "Add" and the window below will show "Message"
5. Click "Apply" or "OK" to save the configuration.
Note: Once this function is enabled and users have enable Motion Detection on that
particular camera, a pop-up screen will appear (as below) to warn users that the DVR has
detected motion
6. Click "Confirm" button
Chapter 6
Pic6-5: Message Alarm
35