Table of Contents
Advertisement
8
Storage Devices
8.4
Writing
The storage devices can be written to in several ways. The most functionally secure way is writing to the storage
device via a data interface.
!
Attention!
The device selected as Default storage is written to by default. To write to another device specify the
path name of the device in the file name ( "Programming Manual").
Example:
With direct programming, the command sequence for saving a label (file XYZ) has the following form:
Ms LBL; XYZ
J
H 100,0,T
S l1;0,0,68,71,104
T 10,10,0,3,pt15;memory card
A 1[NOPRINT]
Ms LBL
•
After transfer of the command sequence, the file XYZ is saved with the commands from J to A.
•
Only one label is printed each time the file XYZ is called up.
•
The [NOPRINT] parameter in command A suppresses the printing of a label when the file is saved.
•
To print the label a variable number of times, use command A [?].
8.5
Storage Device Functions in the Offline Menu
Accessing the Storage device menu is only possible if a storage device is installed and defined as Default
storage "4.1.4" on page 15.
8.5.1
Load Label
Labels whose descriptions are saved on the storage device can be printed using the Load label function.
1. Start Offline menu.
2. Select Storage device > Load label.
The content of the folder "labels" will be shown.
3. Select the desired label.
4. Confirm with OK.
If a label is selected which was saved with a fixed contents and fixed label quantity, the print job is started
immediately.
If additional input on the label description is required, the display requests to enter the variable data.
For label descriptions with a variable label quantity, a prompt to enter the label quantity is displayed.
Enter the label quantity/variable data.
5. Select OK to start the print job.
Command for saving the file XYZ
|
|
| Contents of the file XYZ
|
|
End of save command
39
Hide quick links:
Advertisement
Table of Contents
