Table of Contents
Advertisement
4
Configuration
4.1.3
Print Parameters
Start Offline menu.
Select Setup > Print param..
Parameter
Heat level
Print speed
Transfer print
Warn level
ribbon
Label sensor
Extrapolate pos.
Tear-off mode
Backfeed
Error-Reprint
Meaning
The Heat level setting only affects the test printouts and print
jobs without heat level definition in the software.
Otherwise the heat level defined in the software is used.
Basic print speed setting.
The print speed can be re-specified for each print job via software.
The basic setting is not changed by this.
The print speed setting also affects the test printouts.
On for thermal transfer printing: Sensor for monitoring the transfer
ribbon is activated.
Off for thermal direct printing: Sensor for monitoring the transfer
ribbon is not activated.
The setting can be overwritten for each print job via software. The
basic setting is not changed by this.
Warning via the Ethernet interface by way of an SNMP message or
e-mail sent when the remaining diameter of the ribbon supply roll
undershoots the set value (32–74 mm).
Method for detecting the starting end of the label.
Gap Sensor: Detection using changes in the transparency
between the label and label gap.
Bottom-Reflect: Detection using reflex marks on the bottom of
the medium.
Continuous media:
If cutter is not installed, access only with service key
inserted!
Synchronization of the paper flow when using endless media in
cutting mode.
After loading media select
That way a short feed and a synchronization cut are realized.
The positions of the labels which are between the label sensor and
the printhead are calculated from the first label recognized by the
sensor and the programmed label distance. That way those labels
can be printed.
Positioning the label medium for tearing off at the tear-off plate.
On: Additional advancement of the label medium which positions
the label gap after the last printed label at the dispense plate.
Off: Label advance stops once the last label has fully passed the
print line.
Method for backfeeding the label medium.
Backfeeding is necessary in the cutting mode since the front edge
of the next label has passed the print line when cutting a label.
always: Backfeeding occurs independently of label contents.
smart: Backfeeding only occurs when the next label is not yet fully
prepared cutting the current label. Otherwise, the printing of the
next label is started, interrupted and completed after cutting of the
first label without backfeeding.
On: With a correctable error and corresponding troubleshooting,
the label being printed when the error occurs is repeated.
Off: Print job is continued with the next label.
.
13
Default
0
50 mm/s
On
Off
Gap
Sensor
off
On
smart
On
Hide quick links:
Advertisement
Table of Contents
