INSTALLATION
REGENCY
Because of the extreme heat this fi replace emits, the mantel clearances are critical.
Combustible mantel clearances from top of unit are shown in the diagram below.
Note: A non-combustible mantel may be installed at a lower height if the framing is made of metal studs covered with a non-combustible
board.
These drawings are to scale at 1:6 (one inch = 6 inches)
Mantel can be installed anywhere in shaded area or higher using the above scale.
Note: Ensure the paint that is used on the mantel and the facing is "heat resistant" or the paint
may discolour.
Combustible mantel leg clearances as per diagram:
14
®
SERIES COMBUSTIBLE MANTEL CLEARANCES
REGENCY
MANTEL LEG CLEARANCES
Maximum 1-1/2" projection
at 2" minimum clearance.
®
FPI P36-4 Zero Clearance Direct Vent Gas Fireplace