Table of Contents
Advertisement
Clearances with Vignette Faceplate
Caution Requirements
The top, back and sides of the fireplace are defined by
standoffs. The metal ends of the standoff may NOT be
recessed into combustible construction.
The clearances listed below are minimum
distances unless otherwise stated:
A major cause of chimney related fires
is failure to maintain
required clearances (air space) to com-
bustible materials.
It is of the greatest importance that this
fireplace and vent system
be installed only in accordance with these
instructions.
Clearance to Combustibles from:
Back
0"
Side
0"
Floor
0"
NOTE: The minimum floor clearance must
be maintained from the top surface of the
carpeting, tile, etc.
Mantel Leg Clearances with Vignette Faceplate
Combustible mantel leg clearances from side of unit as per diagram:
Minimum Clearance from Top of Unit to:
Mantel*
Ceiling
Side Wall Clearance
Minimum Vent Clearances:
2-1/2" (64mm) Horizontal Top
1-1/2" (38mm) Horizontal Side
1-1/2" (38mm) Horizontal Bottom
1-1/4" (32mm) Vertical Vent Clearance
1-1/2" (38mm) Vertical Vent Clearance
(0mm)
(0mm)
(0mm)
Alcove Clearances:
Max. Depth
Min. Width
Min. Height
*See mantel clearance instructions.
if these clearances (air space) to combustible materials are not
adhered to. It is of greatest importance that this fireplace and vent
system be installed only in accordance with these instructions.
min. 10" (254mm)
30"
(762mm)
from top of unit.
7-1/2" (191mm)
(Rigid Vent)
(Flex Vent)
36"
(914mm)
48"
(1219mm)
59"
(1499mm)
Regency
installation
WARNING
Fire hazard is an extreme risk
C
F
Clearances for Vignette Faceplate
Fire hazard is an extreme risk if
these clearances are not adhered to.
P33E-11 Zero Clearance Direct Vent Gas Fireplace
®
|
19
Warning
|
19
Advertisement
Table of Contents
