Event Logging; Tftp Server Settings - Symbol WS5000 Series System Reference Manual

Note The command file is not invoked automatically using this method. The correct
method is to use the DHCP option to send the file to the switch.

3.3.1 Event Logging

The service option is a setting to turn on or off the logging feature, which pushes auto-installation event
messages to a log file named CmdProcErrors.txt. This error log file is automatically generated in the same
directory as the system image/configuration/command files if logging is turned on.
These log messages are generated when events such as firmware/configuration upgrades/downgrades occur,
and/or the command file contains errors such as improper syntax, files that are not present on specified TFTP
server, etc.
Table 3.1 Event Logging (Service) Section
Option Value
AutoConfig Log <on|off>

3.3.2 TFTP Server Settings

This section specifies the location of the TFTP server used to download, the names of the system image,
configuration and Kerberos files that need to be downloaded. These settings are used when upgrading/
downgrading firmware, changing configuration files or updating the user database of the Wireless Switch's
built-in Kerberos KDC.
Table 3.2 TFTP Server (Files to Download) Section
Option
TFTP Server <xxx.xxx.xx.xx>
ImageRestore <image file(.sys.img)>
Notes
This selection allows the user to enable or disable the use of the
logging facility. The default is on.
<Value> Notes
This is the TFTP server from where the configuration file, the
image file, and the Kerberos file are downloaded. If the TFTP
server is not specified, it is assumed that the user
downloaded these files manually via CLI copy command or the
auto install will look for them in the Wireless Switch.
If the revision levels are different, then the image file will be
downloaded from the TFTP server. After this step has
completed successfully, the switch will perform a reset and
continue to reboot with the most recent (and valid) system
image available. If any error occurred during the file
processing, the firmware will not be upgraded and an error
message will be logged.
Configuring the WS5000 Series Switch Auto-
3-3