Event Logging; Tftp Server Settings - Symbol WS5000 Series System Reference Manual

Note The command file is not invoked automatically using this method. The correct
method is to use the DHCP option to send the file to the switch.

3.2.1 Event Logging

The service option is a setting to turn on or off the logging feature, which pushes auto-installation event
messages to a log file named CmdProcErrors.txt. This error log file is automatically generated in the same
directory as the system image/configuration/command files if logging is turned on.
These log messages are generated when events such as firmware/configuration upgrades/downgrades occur,
and/or the command file contains errors such as improper syntax, files that are not present on specified TFTP
server, etc.
Table 3.1 Event Logging (Service) Section
Option Value
AutoConfig Logging <on|off> This selection allows the user to enable or disable the use of the logging facility. The

3.2.2 TFTP Server Settings

This section specifies the location of the TFTP server used to download, the names of the system image,
configuration and Kerberos files that need to be downloaded. These settings are used when upgrading/
downgrading firmware, changing configuration files or updating the user database of the Wireless Switch's
built-in Kerberos KDC.
Table 3.2 TFTP Server (Files to Download) Section
Option Value
TFTP Server <xxx.xxx.xx.xx>
ImageRestore <image file (.sys.img)>
ConfigFile <config_name (.cfg)>
Notes
default is on.
Notes
This is the TFTP server from where the configuration file, the image file, and
the Kerberos file are downloaded. If the TFTP server is not specified, it is
assumed that the user downloaded these files manually via CLI copy
command or the auto install will look for them in the Wireless Switch.
If the revision levels are different, then the image file will be downloaded
from the TFTP server. After this step has completed successfully, the switch
will perform a reset and continue to reboot with the most recent (and valid)
system image available. If any error occurred during the file processing, the
firmware will not be upgraded and an error message will be logged.
This is the name of a WS5000 Series Switch configuration. This file is
downloaded automatically from a specified TFTP server or though the CLI
copy command.
If the file is not found, or if there were errors during the TFTP download, the
installation software will abort the configuration immediately and exit.
This is considered a fatal error and any locally specific configurations
should not be applied as well since they can be interrelated to the general
configuration settings. The IP address of the WS will also remain
unchanged. The file name is case sensitive.
Configuring the WS 5000 Series Switch Auto-
3-3