Using On-Board Radius Server; Physical Network Configuration - Symbol WS5000 Series System Reference Manual

5-16
WS5000 Series Switch System Reference Guide
3. Microsoft Windows Server 2000 (or Advanced Server) with SP4 or (newer)
4. Experience with Microsoft Windows operating systems and the WS5000
Note It is possible to use the Wireless Switch User Authentication via Remote RADIUS
Server feature with different configurations than what's provided in this guide.
However, to complete all of the steps in this installation guide the exact configuration
above must be used.

5.3.2 Using On-board RADIUS Server

Management users, authenticated using the onboard RADIUS Server, will be given Read-Only attributes. To
configure the management onboard RADUIUS server, follow the steps provided in
board RADIUS Server on page 2. Add the user with a password. This user must NOT be attached to any group.
Setup on the WS5000 is the same as mentioned in
address of the switch in Remote Administration dialog.

5.3.3 Physical Network Configuration

This guide uses the following network configuration:
Figure 5.12 Physical Network Configuration
For this installation, Windows Server 2000 must be accessible by the WS5000. The simplest way to achieve
this is to configure the WS5000 and Windows Server 2000 so they are on the same physical and IP subnet. If
they are on different IP subnets, the WS5000 must be able to route to the Windows Server 2000.
Configuring an On-board RADIUS
5.2 Configuring an On-
Server. Specify the IP