Version-Up Procedures For Dvedit - Panasonic AY-RP500 Installation Manual

Nonlinear editing system control panel kit
Hide thumbs Also See for AY-RP500:
Table of Contents

Advertisement

VERSION-UP PROCEDURES FOR DVEdit

This manual describes the procedures for upgrading
DVEdit to the newest software.
Observe the following procedures to correctly replace
the existing software.
After replacing the Targa driver, be sure to replace, or
write over, the existing software.
Otherwise, normal operation cannot be expected.
Precautions for Version-up
Targa Driver
The new Targa driver cannot be written over the old
driver to upgrade the version. First, remove the old
driver from DVEdit by uninstalling, then install the new
Targa driver to upgrade the version. After replacing the
Targa driver, be sure to reinstall (or overwrite) DVEdit.
DVEdit Software
In upgrading the DVEdit software version, the new
software can be written over the old software. Different
from the Targa driver, it is not necessary to uninstall the
old software.
Overwrite permits use of the existing A/V data as it is
even after upgrading the version. If the new software is
installed after uninstalling the existing software, all the
data will be erased for a new setup.
Precautions
The following two cases can be considered in installing
the new software in DVEdit.
Carefully replace the existing software by observing the
version-up procedures for each of the three cases
described in the following section.
1. Erasing data from DVEdit already in use
2. Not erasing data from DVEdit already in use
43
Updating Procedures
Erasing Data from DVEdit Already in Use
1.
Virtual Memory Expansion
Observe the manual "Setting up the Virtual Memory" to
properly expand the virtual memory.
2.
Confirming the Version Installed
(a) Confirming the version of the Targa driver in use
Confirm the version of the Targa driver installed in
DVEdit at present. This can be confirmed on the DVR
Information panel. Click "Start", "Program", "TARGA
DV2000" and "DVRInfo" to call this panel on the
screen. Watch the "Software" tag, referring to the
figures below. The version is shown in the Product
Version line at the top.

Advertisement

Table of Contents
loading

Table of Contents