Operating Procedures - Panasonic AW-RP301 Operating Instructions Manual

OPERATING PROCEDURES E
1. Power
Set the power switch on the pan/tilt head AC adapter to
the ON position, then set Power contro! Switch & on
the control panel to the ON position.
2. Panf/tilt Limiter Setting for Pan/tilt Head
If there are obstacles around the pan/tiit head, set the
limiters to limit the operating range (pan left and right
ends, tilt up and down ends) of the pan/tilt head.
Note: The switches on the pan/tilt head have been pre-
set before shipment from the factory on the
assumption that the pan/tilt head would be sus-
pended from the ceiling. If the pan/tilt head is
mounted on a board, for example, be sure to shift
the mounting direction switches on the panj/tilt
head. Unless this is done, рап/ШІ directions will be
reversed and pan/head operation limiter data can-
not be properly stored in the memory. For details
on shifting these switches, refer to INSTALLATION
OF PAN/TILT HEAD at page 13 or the Operating
Instructions for Pan/tilt Head.
-19-
Up tilting limiter
Preset position selection switch
Left panning Lights on
limiter completion
of setting.
Preset
(СШ сан JE ,/ memory
Switch
Lights on
completion mA Right panning
of resetting Down tilting limiter limiter
(D On the AW-RP305, select a pan/till head with CON-
TROR Switch 9.
(2 Left Panning Limiter
Turn the pan/tilt nead to the desired left panning limit
with PAN/TILT Lever €9, keep MEMORY Switch Ө
depressed, and simultaneously press buttons [1] and
[6] of PRESET Switch Ф for 5 seconds or more. When
the desired limit has been set, button [5] of PRESET
Switch 9 lights.
To reset the limit, keep the MEMORY switch ©
depressed, and simultaneously press buttons [1] and
[6] of PRESET Switch @ again for 5 seconds or more.
When the set limit is reset, button [10] of PRESET
Switch © lights.