Panasonic AW-RP305 Service Manual
Pan/tilt contrpol panel/multi pan/tilt control panel
Hide thumbs
Also See for AW-RP305:
- Operating instructions manual (28 pages) ,
- Operating instructions manual (28 pages)
Table of Contents
Advertisement
Quick Links
SPECIFICATIONS
Source Voltage :
Power Consumption :
Pan/tilt Control Output :
System Tally Input :
Auxiliary Control Input :
Switches :
Controls :
Pan/tilt Head Connecting
Cable :
Maximum cable length :
Operating temperature :
Dimensions :
Weight :
Finish :
Weight and dimensions indicated are approximate.
Specifications are subject to change without notice.
ACCESSORIES
Seal .......................................................................................... 1
Rack mounting part ................................................................... 2
Mounting screws ..................................................................... 12
M4x8 mm ........................................................................... 8
M5x8 mm............................................................................ 4
Pan/Tilt Contrpol Panel/Multi Pan/Tilt Control Panel
AW-RP301/AW-RP305
AW-RP301
12 V DC (DC jack)
AW-RP301:
AW-RP305:
AW-RP301:
AW-RP305:
AW-RP301:
AW-RP305:
Control signal (8 pin DIN connector)
Power ON/OFF Switch,CONTROL Switch(AW-RP305 only), LAMP ON/OFF Switch,
IRIS AUTO/MANU Switch,
MEMORY Switch, PRESET Switch, SPEED Switch, DEF Switch, WIP Switch, H/F Switch,
EXT Switch, ND Switch, OP Switch, SPEED SW CHANGE Switch, ZOOM REVERSE Switch,
ZOOM / FOCUS EXCHANGE Switch, FOCUS REVERSE Switch, TILT REVERSE Switch,
PAN REVERSE Switch
IRIS LEVEL Control, ZOOM Lever, FOCUS Lever, PAN/TILT Lever
AW-RP301:
AW-RP305:
500 m (In case of using 10BASE-T cable UTP category-5)
−10°C to +45°C (14°F to +113°F)
210 (W) x 88 (H) x 177 (D) mm [8-1/4" (W) x 3-1/2" (H) x 7" (D)]
2.1 kg (4.6 lbs.)
AV Ivory painting
12 V, 0.3 A
12 V, 0.5 A
Control signal (RJ-45 8P modular jack)
Control signal x 5 (RJ-45 8P modular jack)
Tally signal (2 pin Terminal block)
Tally signal (6 pin Terminal block)
10BASE-T cable : 1 pc.
10BASE-T cable : 1 pc.(per pan/tilt head)
Connecting plate .............................................1
C 1 9 9 8 M a t s u s h i t a C o m m u n i c a t i o n I n d u s t r i a l C o . , L t d .
A l l r i g h t s r e s e r v e d . U n a u t h o r i z e d c o p y i n g a n d
d i s t r i b u t i o n i s a v i o l a t i o n o f l a w .
ORDER NO. BSD9803030C8
AW-RP305
Advertisement
Table of Contents
Related Manuals for Panasonic AW-RP305
Summary of Contents for Panasonic AW-RP305
-
Page 1: Specifications
Auxiliary Control Input : Control signal (8 pin DIN connector) Switches : Power ON/OFF Switch,CONTROL Switch(AW-RP305 only), LAMP ON/OFF Switch, IRIS AUTO/MANU Switch, MEMORY Switch, PRESET Switch, SPEED Switch, DEF Switch, WIP Switch, H/F Switch, EXT Switch, ND Switch, OP Switch, SPEED SW CHANGE Switch, ZOOM REVERSE Switch,... -
Page 2: Table Of Contents
WARNING This service information is designed for experienced repair technicians only and is not designed for use by the general public. It does not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to service a product. Products powered by electricity should be serviced or repaired only by experienced professional technicians. -
Page 3: Major Operating Controls And Their Functions
Set it to the OFF position to switch the halogen lamp off. e Tally Indicator [TALLY] Note: In using the AW-RP305, when a pan/tilt head is On the AW-RP305, the LED corresponding to the selected with CONTROL Switch r, the halogen... - Page 4 Lens Iris Control [IRIS, LEVEL] Note: At the same time as a pan/tilt head is selected with CONTROL Switch r on the AW-RP305, the When IRIS AUTO/MANU Switch u is in the MANU defroster of the selected pan/tilt head is switched on...
-
Page 5: Rear Panel
REVERSE Switch #0 is in the NOR position. HOT Terminal on the AW-RP301 or any of [1] to [5] ter- minals on the AW-RP305 falls to ground voltage level, pan/tilt head moves in the opposite direction if the TILT the corresponding system TALLY indicator e and the REVERSE Switch #0 is in the REV position. -
Page 6: Front Panel
Ground 8-pin DIN connector pin assignment (as viewed from the rear of the control panel) Zoom Focus Tilt control control control control Example of auxillary 10KΩ 100Ω control circuit 6.8KΩ ZOOM 100Ω 10KΩ Iris control FOCUS 20KΩ 100Ω 10KΩ TILT 10KΩ... - Page 7 INSTALLATION OF PAN/TILT @9 Focus Reverse Switch HEAD [FOCUS REVERSE, NOR/REV] Changes the operating direction of FOCUS Lever !9 9 . • Install the pan/tilt head after carefully reading the The lens is focused far when FOCUS Lever !9 is moved Operating Instructions for Pan/tilt Head.
- Page 8 e Place the cover back on the pan/tilt head. Lens Mounting * Be sure not to trap the wires. • Turn the lens lock ring knob fully counterclockwise. • If the lens mount has a cap, remove the cap. • With the lens positioning pin up, mount the lens. DESKTOP SW 1 SW 2...
- Page 9 ZOOM/FOCUS CONTROL A U X C O N T R O L D C 1 2 V I N PAN/TILT CONTROL OUT T A L L Y AW-RP305 PAN/TILT CONTROL DC+15V AC Adaptor for Pan/tilt Head AW-PS300 MIN 250W LAMP AC OUT...
-
Page 10: Operating Procedures
!0 lights. To reset the limit, keep the MEMORY switch o q On the AW-RP305, select a pan/tilt head with CON- depressed, and simultaneously press buttons [7] and [8] TROL Switch r. of PRESET Switch !0 again for 5 seconds or more. - Page 11 In case of the AW-RP305, repeat Steps q, w and e to 3. Pan/tilt Head Presetting store the presettings of all the pan/tilt heads in the mem- q On the AW-RP305, select a pan/tilt head with CON- ory. TROL Switch r.
- Page 12 How to Change Rear Panel Direction q Remove the four screws from both sides of the top cover, and take the top cover off. Remove the top cover. 4 screws (on both sides) w Remove the two screws and take the blank panel off. Rear panel 2 screws (on both sides) Blank panel...
-
Page 17: Main Board
REPLACEMENT PARTS LIST Important Notice Components identified by " " mark have special characteristics important for safety. When replacing any of these components, use only manufacturer's specified parts. RTL : Retention Time Limited (No longer available after discontinuing product). REF. NO. PART NO. -
Page 18: Sw/Cam Board
REF. NO. PART NO. DESCRIPTION REF. NO. PART NO. DESCRIPTION C501-527 YGM1F104Z1ET Ceramic 0.1 µ F 25V SW/CAM BOARD C528 RVS0J220M Electrolytic 22 µ F 6.3V C529-532 YGM1F104Z1ET Ceramic 0.1 µ F 25V C533,534 5CH220J5VT Ceramic 22 pF PCB2 (RTL) WRP31JKZ1A Printed Circuit Board Assy C535... -
Page 19: Rear Board
REF. NO. PART NO. DESCRIPTION REF. NO. PART NO. DESCRIPTION S9-13 15EL1220000 Switch JOYSTICK BOARD 13AL0600040 Switch D 13AL0600050 Switch Y S16-20 15EL1220000 Switch PCB4 (RTL) WRP51JKY1A Printed Circuit Board Assy SSSB022P6N Slide Switch R1-3 RKJXC10KB2 Variable Resistor 10K ohms R4-31 ERJ8GEY0R00V Carbon... - Page 20 200 ohms 1/16W 1A1A063A Rear Panel V2GA0065A4 Cord Clamp R535 ERJ3GEYJ333V Carbon 33K ohms 1/16W M23 Y 7C1A030A Main Label for AW-RP305/USA/Canada R539 ERJ3GEYJ201V Carbon 200 ohms 1/16W R541 ERJ3GEYJ472V Carbon 4.7K ohms 1/16W 7C1A031A Main Label for AW-RP305/B/G R547...
-
Page 21: Sw/Cam Board
REF. NO. PART NO. DESCRIPTION REF. NO. PART NO. DESCRIPTION R657 ERJ3GEY0R00V Carbon 0 ohm 1/16W SW/CAM BOARD C501-527 YGM1F104Z1ET Ceramic 0.1 µ F 25V C528 RVS0J220M Electrolytic 22 µ F 6.3V C529-532 YGM1F104Z1ET Ceramic 0.1 µ F 25V PCB2 (RTL) WRP35JKZ1A Printed Circuit Board Assy C533,534... -
Page 22: Rear Board
Rack Angle YWT20X25C03 Polyethylene Bag PE35X50C05 Polyethylene Bag 0C1A009AA Packaging Ass’y V8FA0137A4 Packaging Label for AW-RP305/USA/Canada REAR BOARD V8FA0140A4 Packaging Label for AW-RP305/B/G V8FA0070A4 Packaging Label PCB3 (RTL) WRP35JKY1A Printed Circuit Board Assy C1-37 400103XKT Ceramic 0.01 µ F J2-6 285D9880J101...