Operating Procedures - Panasonic AW-RP505 Operating Instructions Manual

OPERATING PROCEDURES

1.Power
Press the power switch on each pan/tilt head AC
adapter and the power switch on the multiport hub AC
adapter to the ON position, then press the power
switch on the multiport hub to the ON position. Finally,
press the power control switch on the multi hybrid con-
trol panel to the ON position.
2. Pan/tilt Limiter Setting for Each
Pan/tilt Heads
If there are obstacles around the pan/tilt head, set the
limiters to limit the operating range (pan left and right
ends, tilt up and down ends) of the pan/tilt head.
Note: The switches on the pan/tilt head have been pre-
set before shipment from the factory on the
assumption that the pan/tilt head would be sus-
pended from the ceiling.
mounted on a board, for example, be sure to shift
the mounting direction switches on the pan/tilt
head. Unless this is done, pan/tilt directions will be
reversed and pan/head operation limiter data can-
not be properly stored in the memory. For details
on shifting these switches, refer to INSTALLATION
OF PAN/TILT HEAD at page 19 or the Operating
Instructions for Pan/tilt Head.
If the pan/tilt head is
-26-
Up tilting limiter
Left panning
limiter
1 2
6 7
M E M O RY
Preset
memory
Down tilting limiter
switch
q Select a pan/tilt head with the CONTROL switch.
w Left Panning Limiter
Turn the pan/tilt head to the desired left panning limit
with PAN/TILT Lever #8 , keep MEMORY Switch @7
depressed, and simultaneously press buttons [1] and
[6] of PRESET Switch @8 for 5 seconds or more. When
the desired limit has been set, button [5] of PRESET
Switch @8 lights.
To reset the limit, keep the MEMORY switch @7
depressed, and simultaneously press buttons [1] and
[6] of PRESET Switch @8 again for 5 seconds or more.
When the set limit is reset, button [10] of PRESET
Switch @8 lights.
Preset position selection switch
Lights on
completion
P R E S E T
3 4 5
of setting.
Lights on
8 9 1 0
completion
of resetting
Right panning
limiter