Table of Contents
Advertisement
DVEdit INSPECTION DETAILS
heck with "Device Setup" on the "Special" panel
that the device settings agree with the connections.
Clips can be created using the manual digitizer.
(About 5 each of Ado, Vdo, A/V)
Check that an NTSC image is shown in the lower
right part of the VGA monitor.
Clips can be created using the batch digitizer.
(About 5 each of Ado, Vdo, A/V)
Check that an NTSC image is shown in the lower
right part of the VGA monitor.
Clips can be created using the title editor.
(About 5)
Transition settings can be made using the
sequence editor, and can be reproduced as
per the settings.
Transition time is 50 frames. Check by "Preview"
that the following wipe operation is normal. The
transition panel is shown for reference (page 55).
• Basic (H, V, Square, Round, Star, Heart; 5 from
the right on the third line from the bottom; 4 from
the right on the first line from the bottom; CUT,
MIX)
• Slide (1, 2, 3, 4 from the left on the first line from
the top; all on the fourth line from the top; 1, 2
from the left on the fifth line from the top)
• Compress (All on the third line from the top)
• Zoom (1 from the left on the first line from the top;
1 from the left on the second line from the top; 1
from the left on the third line from the top; 1 from
the left on the fourth line from the top)
• Zoom + Fade (1 from the left on the first line from
the top; 1 from the left from the second line from
the top; 1 from the left on the third line from the
top; 1 from the left on the fourth line from the top)
Title settings can be made using the
sequence editor, and can be reproduced as
per the settings.
Video key settings can be made using the
sequence editor, and can be reproduced as
per the settings.
Audio Modify (Level (channels 1 and 2), VR,
Balance VR, Master VR) settings can be made
using the sequence editor, and can be
reproduced as per the settings.
Rendering operation by the sequence editor is
normal.
Render those parts which include transitions, key
video, and key title. The rendered clips are
created as per the settings.
54
The results of editing using the sequence
editor can be saved as clips. They can be
reopened and reproduced.
Check trim mode operations with the sequence
editor.
Check also that two NTSC windows are shown in
the lower left part of the VGA monitor.
Check the images in the NTSC windows in the
lower left part of the VGA monitor.
Check that the images in the windows are correct
when clip in and out points are selected.
Check the frame accuracy with the clip editor.
Check that the clips created using the batch
digitizer have correct frame accuracy.
Sequence data can be recorded by a video
taperecorder by Rec To Video.
Also adjust the timecode, video, and frame
accuracy, and check that sequence data is
recorded as per the settings.
Advertisement
Table of Contents
