Table of Contents
Advertisement
Setting up the hard disk
It must be set up so that the hard disk can be used.
1. Turn on the power, and start up Windows NT.
2. Click
Start
.
From Programs in the Start Menu, click
"Administrative Tools"
p
The program starts up.
3. When the Disk Administrator starts up, a list appears
showing the bulk-storage devices such as hard
disks and CD-ROM.
4. The contents displayed are as follows:
Disk 0:
Always the IDE drive.
Disk 1 and after:
SCSI hard disks connected to Channel A, in
order from the lowest SCSI ID.
SCSI hard disks connected to Channel B, in
order from the lowest SCSI ID.
Last disk: CD-ROM
(No difference, whether inside or outside the com-
puter.)
27
Disk Administrator".
Note: When setting up the disk, if the audio or video
hard disk display is for a logical drive (displayed
in blue) rather than the primary partition (dis-
played in dark blue), the procedure described
below must be performed in order to change to
the primary partition.
1) Click on (select) the logical drive area (dis-
played in blue).
2) Click "Delete" in the "Partition" menu on the
menu bar (at the top of the window).
3) When the "Confirm" message appears, click
Yes
.
4) Click the right mouse button on the shaded
area
, and then click "Delete" in the
menu that appears.
5) When the "Confirm" message appears, click
Yes
.
6) The lines in the shaded area are now
reversed.
7) With the lines sloping in this new direction
(
), perform the setup operation again.
Advertisement
Table of Contents
