Table of Contents
Advertisement
S-VHS VCR (No RS422 control)
Set [Genlock Input Control] to "Disabled".
Video output monitor
Computer (rear)
TARGA board
JOG board
MEMO
• Use a coaxial relay plug when connecting two coaxial cables (with BNC connectors) together.
• When not using the REF OUT signal (loop-through) on the JOG board, turn off the 75Ω terminator switch on the JOG
board; and connect the termination (accessory) to the REF OUT cable.
• If a DVCPRO series VCR is used, the EE output from the VCR lags the input signal by about five frames.
36
CV/CS OUT
R AUDIO OUT
L AUDIO OUT
S-VIDEO OUT
S VIDEO IN
R AUDIO IN
L AUDIO IN
XLR3-RCA pin
conversion cable
Y/G OUT
Relay Plug
Analog I/O Cable
REF IN
LTC/REF cable
Coaxial relay plug
REF OUT cable
Termination
XLR3-RCA pin
conversion cable
S-VHS
Advertisement
Table of Contents
