Panasonic AY-RP500 Installation Manual page 15

12. The Windows NT Diagnostics Program window
appears.
Click the "Resources" label. The resource list shown
below appears (not in the same layout).
Note: "DVRNTDRV" indicates the TARGA DV2000
board. Check which number is used for the
IRQ.
After checking, click
13. Change the display driver.
1) Click Start . Select "Settings" in the Start Menu.
The Control Panel opens.
"Display".
2) Select "Settings" from "Display Properties" and
click .
Display Types
3) Click Change in "Display Types".
4) Click Have Disk in "Display Modification".
5) The directory of the display driver is to be
opened, so enter
"c:\TARGA2KVD\WINNT\Display" and click
6) Confirm that "Truevision DVR Display" is dis-
played on the screen and click
7) The message "The drivers were successfully
installed" appears. Click
13
to close the window.
OK
Then double-click
OK .
.
OK
.
OK
8) Click Close in "Display Types".
9) Click in "Screen Properties".
Close
10) The message "You must restart your computer..."
appears. Click Yes .
11) Windows NT starts up. When the Control Panel
opens, close it.
When the message "A new graphics driver has
been installed" appears, click
12) Click and drag the mark on the frame of the
desktop area in "Screen Properties" to adjust it for
the resolution of 1152 x 870 pixels. Here, confirm
that the font size is "Small Fonts", and that the
Refresh Frequency is 75 Hz.
13) Click Test , and click
The test screen appears.
14) If the test screen is displayed correctly, click
Yes .
15) Click in "Display Properties" to close this
OK
screen. The resolution will change.
Note: Be sure to modify the display and test it.
Otherwise, the display will not be correct.
.
OK
to enter test mode.
OK