Operating Procedures - Panasonic AW-RP501 Operating Instructions Manual

OPERATING PROCEDURES

1.Power
Set the power switch on the pan/tilt head AC adapter to
the ON position, then set Power ON/OFF Switch w on
the control panel to the ON position.
2. Pan/tilt Limiter Setting for Pan/tilt Head
If there are obstacles around the pan/tilt head, set the
limiters to limit the operating range (pan left and right
ends, tilt up and down ends) of the pan/tilt head.
Note: The switches on the pan/tilt head have been pre-
set before shipment from the factory on the
assumption that the pan/tilt head would be sus-
pended from the ceiling.
mounted on a board, for example, be sure to shift
the mounting direction switches on the pan/tilt
head. Unless this is done, pan/tilt directions will be
reversed and pan/head operation limiter data can-
not be properly stored in the memory. For details
on shifting these switches, refer to INSTALLATION
OF PAN/TILT HEAD at page 18 or the Operating
Instructions for Pan/tilt Head.
If the pan/tilt head is
-25-
Up tilting limiter
Left panning
limiter
1 2
6 7
M E M O RY
Preset
memory
Down tilting limiter
switch
q Left Panning Limiter
Turn the pan/tilt head to the desired left panning limit
with PAN/TILT Lever #8 , keep MEMORY Switch @7
depressed, and simultaneously press buttons [1] and
[6] of PRESET Switches @8 for 5 seconds or more.
When the desired limit has been set, button [5] of PRE-
SET Switches @8 lights.
To reset the limit, keep the MEMORY switch @7
depressed, and simultaneously press buttons [1] and
[6] of PRESET Switches @8 again for 5 seconds or
more. When the set limit is reset, button [10] of PRE-
SET Switches @8 lights.
Preset position selection switch
Lights on
completion
P R E S E T
3 4 5
of setting.
Lights on
completion
8 9 1 0
of resetting
Right panning
limiter