Table of Contents
Advertisement
Connecting the VCR
Indicates an example of system connection.
The system connection diagram shown below is intended as an example. The actual connection locations may differ
depending on the model of computer used.
When connecting a video cassette recorder designed for commercial applications
As in the figure below, [Genlock Input Control] is set to "Blackburst Genlock Input" if [REF IN] is input to the TARGA
board. For details on setup, read the "Special" section in the software manual.
Analog I/O cable
Computer (rear)
TARGA board
JOG board
RS422-1
LTC/REF cable
VCR/JOGPAD cable
34
S-VIDEO OUT
R-Y/R OUT
B-Y/B OUT
Y/G OUT
R AUDIO OUT
L AUDIO OUT
R-Y/R IN
B-Y/B IN
Y/G IN
R AUDIO IN
L AUDIO IN
REF IN
LTC/REF
LTC OUT
LTC IN
REF IN
RS422-2
Relay Plug
Sync signal generator
Video output
Audio output
Commercial VCR
Reference input
RS422
Video output monitor
Speakers with built-in amplifiers
L
R
EE output
Advertisement
Table of Contents
